I would like to setup scheduled task for my systems (CR1000 logger). I've tried to but the schedule never starts. I would appreciate if someone could help me get started. Thanks! /Fredrik
PS. I'm using Loggernet 4.1
Hey Guys my name is Mark.Well Vindteck i think that if you want to know some solution of your problem then you must visit that url:
campbellsci.com/loggernet-specifications
* Last updated by: markspend1 on 7/13/2013 @ 6:11 AM *
Vindtek,
That's a pretty broad question, so it might be best to contact your Campbell Scientific office and request help (or provide more details).
That being said, here are a few things to check before calling:
Can you run the task manually by going to the Task Master's Status tab and choosing Run Selected Task?
Is the Pause All Tasks check box disabled?
On the Status tab, check the Last time to Run, Next Time to Run fields.
Dana W.
Well, I'm not using the task master. I'm checking off boxes for scheduling in the setup section. I will check what you mentioned and get back to you.
Sorry, I misunderstood your request.
If you are trying to set up scheduled data collection, make sure that the Pause Schedule box is not enabled in the Status Monitor application, and also review the informational columns that tell you when the next scheduled data collection should occur and the last time, if any, it occurred.
Dana W.
You can use load cells for this purpose. Load cells are best products to connect with others. A lot lo different kinds of load cells are there in these days. like Single Ended Beams ,Double ended Beams ,Cross Beams,S-type Beams .
* Last updated by: Nindamark321 on 5/29/2014 @ 12:35 AM *