Hello,
I have 3 SR50A measuring distance to a snow surface on sea ice. I set the SDI 12 id's to 0, 1, and 2 in the lab, and tested the program with all of the other sensors that make up our site. Everything worked fine. After we transported the equipment to the measurement site and got everything hooked up, all three SR50A only give NaN. They are all using the same power, so this may be the issue and we're heading out to check that presently, but I wanted to see if the SR50A can somehow reset their ID's and if they would give NaN's if all of them had done so. Any ideas are welcome, and thanks in advance for any help.
UPDATE: It was a power issue.
* Last updated by: jmjones81 on 1/16/2015 @ 6:18 PM *