Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Is it possible to control cr1000 control port via RTMC Pro

mortenx Mar 9, 2015 03:48 PM

Is it possible to control loger(cr1000) control/serial port via RTMC Pro?

Dana Mar 10, 2015 03:27 PM

There are switches and value setters in RTMC Pro that will allow you to set ports high/low. I don't quite understand what you are attempting to do, since you mention controlling a serial port. What kind of control do you want to do?

Dana

mortenx Mar 11, 2015 10:53 AM

Is it possible to make this "set ports high/low" program via Short Cut ?
I found there are only port status option...

Terri Mar 19, 2015 10:10 PM

Will "Simple Control with Deadband" do what you need? It sets ports C1-C8 high or low. Each control entered will use a different Control port.

Log in or register to post/reply in the forum.